K&M Electrical have successfully tested, maintained and installed various makes and models , from mains powered to battery back up systems. The systems and equipment have changed over the years, from extra low voltage systems to high voltage systems and intelligent addressable systems such as KNX Emergency systems and Legrand Galaxy which are a totally automated system with self testing and remote reporting facilities.
K&M Electrical has a team of experienced qualified electricians which are available 24/7 to service your Emergency lighting equipment.
With a large number of clients now requiring emergency lighting checks, we can provide a one stop shop to cover a number of your building emergency services including other electrical repairs or installations you may need at the same time.
What is Emergency Lighting?
An emergency light is a battery-backed lighting device that comes on automatically when a building experiences a power outage or in the event of fire. Emergency lights are standard in new commercial and high occupancy residential buildings, such as college dormitories. The NZ building codes require that they be installed in older buildings installations.
By the nature of the device, an emergency light is designed to come on when the power goes out. Every model, therefore requires some sort of a battery or generator system that could provide electricity to the lights during a blackout. The earliest models were incandescent light bulbs which could dimly light an area during a blackout and perhaps provide enough light to solve the power problem or evacuate the building. It was quickly realized, however, that a more focused, brighter, and longer-lasting light was needed.
Modern emergency floodlight provides a high-brightness, wide-coverage light that can illuminate an area quite well. Some lights are halogen, and provide a light source and intensity similar to that of an automobile headlight.
Early battery backup systems were huge, dwarfing the size of the lights for which they provided power. The systems normally used lead acid batteries to store a full 230 volt charge. For comparison, an automobile uses a single lead acid battery as part of the ignition system. Simple transistor or relay technology was used to switch on the lights and battery supply in the event of a power failure. The size of these units, as well as the weight and cost, made them relatively rare installations. As technology developed further, the voltage requirements for lights dropped, and subsequently the size of the batteries was reduced as well. Modern lights are only as large as the bulbs themselves – the battery fits quite well in the base of the fixture.
Up to date Installations
Up to date emergency lighting is installed in virtually every commercial and high occupancy residential building. The lights consist of one or more incandescent bulbs or one or more clusters of high-intensity light-emitting diodes (LED). The emergency lighting heads are usually either PAR 36 sealed beams or wedge base lamps. All units have some sort of a reflector to focus and intensify the light they produce. This can either be in the form of a plastic cover over the fixture, or reflector placed behind the light source.
Most individual light sources can be rotated and aimed for where light is needed most in an emergency, such as toward fire exits. Modern fixtures usually have a test button of some sort which temporarily overrides the unit and causes it to switch on the lights and operate from battery power even if the main power is still on.
Modern systems are operated with relatively low voltage, usually from 12 to 24 volts. This both reduces the size of the batteries required and reduces the load on the circuit to which the emergency light is wired.
Up to date fixtures include a small transformer in the base of the fixture which reduces the voltage from main current to the low power required by the lights. Batteries are commonly made of lead-calcium, and can last for 10 years or more on continuous charge. Most emergency lights last for a minimum of 90 minutes on battery power during a power outage.
K&M Electrical is based in Tauranga and owned by Matt Lombard, a registered electrician with over ten years experience in the industry. Give Matt a call on 0800 020 097 to discuss your job now.
Need a quote or a job done ASAP? Call Matt now on 0800 020 097
“Awesome job Matt did with our garden lights on patio. Absolutely a quality tradesman !”
“Matt redid the wiring to our roller door so it wasn’t making a humming noise at the control box and Jamming half way while closing”
“Matt fixed our exhaust fan and pre-wired our house and did an awesome job plus he cleaned up.”